Pillow-type packing machine maintenance notes!

1.Pillow packing machine temperature is too high,If the speed is too slow and the heat resistance of the outer coating is poor, the sealing will appear the marks of scorch and wrinkle.

2. The tool base is too high or too low, the packaging speed is too fast, when the push rod and the cutter are not synchronized, the cutter will cut on the product maintenance method is to reduce the packaging speed, adjust the height of the end sealing parts, make the center of the sealing knife in the middle of the product height.

3. The color of the film color label is too light, and the film drives to slip. When the tracking of the color label is not opened, the cutting position will deviate from the color label. In the man-machine interface, change the tracking mode to “ Tracking cutting & throughout; .

4. pillow-type packaging machine solid-state breaker burnt out, temperature control meter damage, thermocouple damage temperature meter can not control the temperature, the maintenance method is to replace the couple, replace the temperature control meter (see the figure on the right), replace the heating body.

5.the speed is too fast, envelop inner layer thermal sealing is poor, the temperature is too low seal will appear leakage or not firm, the maintenance method is to slow down the speed, raise the temperature, replace the film material.


枕式包装机


6.pillow packing machine air pressure is not right, cylinder swing rod is loose, heating temperature is low, hot press roll and drive roll not parallel will appear heat sealing, maintenance method is to adjust the parallelism, adjust the temperature and air pressure to tighten. And it should be noted that the induction aviation plug must be inserted before the power supply, and lock the screw; Do not use metal cover and container, and do not press the start button on the metal surface, otherwise the machine will be damaged; During the working process, touch the surface of the induction head frequently to check whether it is overheated. If hot hands are found, stop heating and work after cooling; There will be high pressure in pillow-type packaging body, the bottom plate has electricity, maintenance must pay attention to, so as to avoid personal danger.