Pillow packing machine in the use of the process of what kind of failure?

Pillow packing machine in the use of the process of what kind of failure?Pillow packaging machine belongs to a kind of packaging machine, and this kind of packaging machine half more harsh environment work, so pillow packaging machine is prone to failure, and a failure if not professional knowledge is difficult to repair.


Pillow packing machine in the use of the process of what kind of failure?

1,When the temperature is too high and the speed is too slow, and the heat resistance of the outer layer of the envelope is poor, the sealing will appear scorched and wrinkled marks.

2,The air pressure is not right, the cylinder swing rod is loose, the heating temperature is low, and the hot pressing roller and the driving roller are not parallel to each other, when the heat sealing is bad, the maintenance method is to adjust the parallelism, adjust the temperature and air pressure to make it tight.

3,If the temperature is too low, the sealing will be leaky or not firm. The maintenance method is to slow down the speed, raise the temperature and replace the material of the film.

And it should be noted that the induction aviation plug must be inserted before the power supply, and lock the screw; Do not use metal cover and container, and do not press the start button on the metal surface, otherwise the machine will be damaged; During the working process, touch the surface of the induction head frequently to check whether it is overheated. If hot hands are found, stop heating and work after cooling; There will be high pressure in pillow-type packaging body, the bottom plate has electricity, maintenance must pay attention to, so as to avoid personal danger.

4,The tool base is too high or too low, the packaging speed is too fast, when the push rod and the cutter are not synchronized, the cutter will cut on the product maintenance method is to reduce the packaging speed, adjust the height of the end sealing parts, make the center of the sealing knife in the middle of the height of the product.

5,The color of the film color label is too light, the film drive skidding, color label tracking is not open when the cut off position deviates from the color label, then the maintenance method is to refer to the packaging machine manual, adjust its sensitivity; In the man-machine interface, change the tracking mode to “ Tracking cutting & throughout; .

6,The solid state breaker is burnt out, the temperature control meter is damaged, and the thermometer cannot control the temperature when the thermocouple is damaged.